Hazard Monitoring Devices
Our Products
M-JET
Hazard monitoring system without display
Strong casing.
Dustproof and waterproof casing.
Remote management use.
2 belt speed sensors.
2 choke and level sensors.
2 follower shaft position sensors.
5 bearing temperature sensors.
2 chain elongation sensors.
3 analogic sensor
4 belt alignment sensors.
24 V DC 350 mA
Option: 110-230V AC 150 mA.
EN 61326 -1 CEM Electromagnetic compatibility.
EN 61010 -1 Safety electric device.
Stainless steel box for ATEX zone European regulation 2014/34UE.
The hazard monitoring devices are able to monitor bucket elevators, belt conveyors, chain conveyors and screw conveyors.
Our hazard monitoring system analyses the data sent by the sensors installed on equipment and save the eventual defects events. According to the setting, the M-JET+ or the M-JET sends alarms and commands the stopping of the conveyor.
M-JET+ or M-JET monitors the following :
Under speed due to belt slip on the pulley. To check comparing with the nominal speed.
Bearing temperature using sensor PT100 or NTC.
Belt misalignment using sensors with or without contact.
Material jam in conveyor entry or exit using capacitive sensor.
Chain elongation measured by inductive sensor and targets.
Motor power measurement with specific electrical consumption.
Shaft position measured by sensor 4-20mA.
The operating control of the system is realized by output relays :
Directly on the power relay of the motor.
By the global PLC of the facilities.
Verifying the conveyor operation can be achieved by :
On computer screen by internal website (directly with laptop or by Network LAN).
By message on the email box (events and maintenance operation plan).